代码拉取完成,页面将自动刷新
同步操作将从 隨風飛翔/u-boot-MT7621 强制同步,此操作会覆盖自 Fork 仓库以来所做的任何修改,且无法恢复!!!
确定后同步将在后台操作,完成时将刷新页面,请耐心等待。
Ralink/MediaTek U-Boot for MIPS SoC
RT3052/RT3352/RT3883/RT5350/MT7620/MT7621/MT7628/MT7688
Based on MediaTek SDK 5.0.1.0
BUILD TOOLS
For MT7621 U-Boot:
- extract 'tools/mips-2012.03.tar.bz2' to /opt
For RT3XXX/MT7620/MT7628 U-Boot:
- extract 'tools/buildroot-gcc342.tar.bz2' to /opt
Both toolchains require x86 (32-bit) Linux environment.
BUILD INSTRUCTIONS
(mips-2012.03 - 32bit, to run the copiler in 64x - install ia32-libs )
# sudo apt-get install ia32-libs
- Run 'make menuconfig', choose [Exit] and confirm [Save]. This is important step!
- Run 'make'.
- Use image file uboot.bin (ROM mode) for NOR and SPI-flash boards.
- Use image file uboot.img (RAM mode) for NAND-flash (or RT3XXX SPI-flash) boards
To clean U-Boot tree:
- Run 'make clean'.
- Run 'make unconfig'.
NOTE:
1. U-Boot images for most ASUS devices is already builded.
2. U-Boot is configured for UART baud rate 115200.
3. All profiles has disabled option "Enable all Ethernet PHY" to prevent LAN-WAN
spoofing (EPHY will be enabled later in FW logic). To force enable EPHY (e.g. for
use OpenWRT/PandoraBox), select option "Enable all Ethernet PHY".
FLASH INSTRUCTIONS
- Upload appropriate U-Boot image file to router's /tmp dir (e.g. via WinSCP).
- Check U-Boot image checksum and compare with uboot.md5:
md5sum /tmp/uboot.bin
- Flash checked U-Boot via SSH or Telnet console (flash duration ~3 sec):
mtd_write write /tmp/uboot.bin Bootloader
- Reboot router.
WARNING
- Do not remove power supply during flash U-Boot!!!
- Device may be bricked due to your incorrect actions!!!
此处可能存在不合适展示的内容,页面不予展示。您可通过相关编辑功能自查并修改。
如您确认内容无涉及 不当用语 / 纯广告导流 / 暴力 / 低俗色情 / 侵权 / 盗版 / 虚假 / 无价值内容或违法国家有关法律法规的内容,可点击提交进行申诉,我们将尽快为您处理。