同步操作将从 ApolloAuto/apollo 强制同步,此操作会覆盖自 Fork 仓库以来所做的任何修改,且无法恢复!!!
确定后同步将在后台操作,完成时将刷新页面,请耐心等待。
This quick start focuses on Apollo 1.5 new features. For general Apollo concepts, please refer to Apollo 1.0 Quick Start and Apollo Software Installation Guide.
For vehicle onboard test, make sure you have calibrated the extrinsic parameters between the LiDAR and the GNSS/INS. For sensor calibration, please refer to Apollo 1.5 LiDAR calibration guide before you proceed.
Launch Docker Release Container
Launch HMI
Use your favorite browser to access HMI web service in your host machine browser with URL http://localhost:8887
Select Vehicle and Map
You'll be required to setup profile before doing anything else. Click the dropdown menu to select your HDMap and vehicle in use. The list are defined in HMI config file.
Note: It's also possible to change profile on the right panel of HMI, but just remember to click "Reset All" on the top-right corner to restart the system.
Start Modules
Set up the system by clicking the "Setup" button on left panel.
(New!) Be Cautious When Starting Autonomous Driving
Make sure all modules are on and hardware is ready, and the vehicle is in a good state which is safe to enter auto mode to follow the traffic to destination.
Click the "Start Auto" button, then it will drive you there!
此处可能存在不合适展示的内容,页面不予展示。您可通过相关编辑功能自查并修改。
如您确认内容无涉及 不当用语 / 纯广告导流 / 暴力 / 低俗色情 / 侵权 / 盗版 / 虚假 / 无价值内容或违法国家有关法律法规的内容,可点击提交进行申诉,我们将尽快为您处理。